![]() To connect the desired output signal to an actual function, click on the spindle setup tab and specify the output number that you applied the pin #16 (under relay control, or flood mist control).Įxample: if you want to control a router from the relay from the AC line (white = neutral, black = live and green = ground), understanding that the neutral and live create the completed circuit, either the black or the neutral can pass through the relay. For instance, in Mach3, go to config -> ports and pins -> click on the output signals tab and enter the pin number 16 on the signal that you wish to control. ![]() Pin #16 will control the relay from the control software such as Mach3 or Linuxcnc. In other words, the connection between P and S will only connect together if the relay is active and will be unconnected if the relay is not active. ![]() ![]() The S a normally open connection to P and O is a normally closed connection to P. The S and O are the other terminals that you may use. ![]() If you want to use the relay, there will always be a wire in the P terminal. As shown in the picture, there are three connections for the relay: P, S and O. Relay Operation: The relay on the breakout board is like having an automatic switch that can be triggered by g-code M3/M4 and M5. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |